You want to make sure when you press the up-button the desired mode button is turning off, not on, to make sure the remote is performing the power scan.Ĭontinue to press the up-button about once every two seconds. The up-button us the button just above the “Select” button, as shown in the image below. While the desired mode button is lit steady you can begin pressing the up-button. Once released your desire mode button should stop blinking and become steady. While the desired mode button is blinking please press and release the big red power button (not the smaller “TV” power button if present). Press and release the big red power button. Release the mode button and the button you are programming will begin to blink.ģ.
Press and hold the mode button you’d like to program for approximately 10 seconds and all of the mode buttons will light up. VCR/DVD: This button is used to be programmed to your VCR or DVD player so you can control the power, and with DISH Network remotes that control DVR receivers you can control the play, pause, stop, rewind and other VCR/DVD functions.ĪUX: Auxillary mode is used to program your remote to additional electronic devices in your home theater system, such as an additional VCR/DVD players or stereo equipment. Your remote should usually be in SAT mode for normal viewing functions. When your remote is programmed to your TV, you do not need to be in TV mode to control your volume, this can be done from SAT mode. TV: When in this mode your remote will control your television, such as volume functions and changing the channels or inputs on your television. Press and hold the mode button.Īt the top of your DISH Network remote there are four clear buttons, these are the mode buttons that are used to select which device you’d like your remote to control. Make sure the device you are programming your DISH Network remote to control is powered on and you are standing within 10-feet of it and have the remote pointed directly at it with no obstructions in between – including any glass entertainment center doors or other seemingly “see through” objects. Prepare your device and remote for the power scan. In this instance you can perform a power scan.Ī power scan scans through all of the remote codes from 000-999 while sending out a signal to power off, you’ll know when you’ve found the code that works with your device when it turns off. DISH Network works hard to maintain an accurate and comprehensive remote code database, but sometimes the codes provided do not work for your device or there are no current codes available. Being able to use one remote to control your entire entertainment center simplifies and enhances your viewing.
DISH Network remotes are designed to not only control your DISH Network receiver but also most other devices in your home theater system.